Connect the JCS 1200 Management Module to the Network Through a Serial Connection

To connect the management module to the network using the serial port:

1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and connect the strap to one of the ESD points on the chassis. For more information about ESD, see the JCS 1200 Platform Hardware Guide.
2. Plug one end of an RJ-45 serial cable into the serial port on the management module. See Figure 8 for the location of ports on the management module.

   Note: Some consoles require that you use an AMM adapter. If needed, plug an AMM adapter into the serial port on the management module, and then connect the serial cable. For information about the AMM adapter pinouts, see the JCS 1200 Platform Hardware Guide.

3. Connect the other end of the serial cable to your console.