Navigation
Supported Platforms
Related Documentation
- M, PTX, T Series
- Configuring Redundant Pseudowires for Layer 2 Circuits and VPLS
switchover-delay
Syntax
switchover-delay milliseconds;
Hierarchy Level
[edit logical-systems logical-system-name protocols l2circuit neighbor address interface interface-name],[edit logical-systems logical-system-name routing-instances routing-instance-name protocols vpls neighbor address],[edit protocols l2circuit neighbor address interface interface-name],[edit routing-instances routing-instance-name protocols vpls neighbor address]
Release Information
Statement introduced in Junos OS Release 9.2.
Description
After the primary pseudowire goes down, specifies the delay (in milliseconds) to wait before the backup pseudowire takes over. You configure this statement for each backup neighbor configuration to adjust the switchover time after a failure is detected.
Options
milliseconds—Specify the time to wait before switching to the backup pseudowire after the primary pseudowire fails.
Default: 10,000 milliseconds
Range: 0 through 180,000 milliseconds
Required Privilege Level
routing—To view this statement in the configuration.
routing-control—To add this statement to the configuration.
Related Documentation
- M, PTX, T Series
- Configuring Redundant Pseudowires for Layer 2 Circuits and VPLS
Published: 2013-01-11
Supported Platforms
Related Documentation
- M, PTX, T Series
- Configuring Redundant Pseudowires for Layer 2 Circuits and VPLS
