Navigation
Supported Platforms
Configuring ANCP Neighbors
You must configure each neighboring access node that you want ANCP to monitor and potentially shape traffic for. Some neighbor settings override globally configured values.
To configure an ANCP neighbor:
- Specify the IP address of the neighbor.[edit protocols ancp]user@host# set neighbor 10.2.3.4
- (Optional) Configure pre-ietf mode when the neighbor does
not support the current IETF standard and pre-ietf mode is not configured
globally.[edit protocols ancp neighbor 10.2.3.4]user@host# set pre-ietf-mode
- (Optional) Configure ietf mode when the neighbor supports
the current IETF standard and pre-ietf mode is configured globally.[edit protocols ancp neighbor 10.2.3.4]user@host# set ietf-mode
- (Optional) Configure the interval in seconds between ANCP
adjacency messages exchanged with this neighbor.[edit protocols ancp neighbor 10.2.3.4]user@host# set adjacency-timer 20
- (Optional) Specify the maximum number of discovery table
entries that are accepted from this neighbor.[edit protocols ancp neighbor 10.2.3.4]user@host# set maximum-discovery-table-entries 10000
