Navigation
Supported Platforms
Configuring a Static or Dynamic VLAN Subscriber Interface over Aggregated Ethernet
You can configure a subscriber link represented by a static virtual LAN (VLAN) stacked on an aggregated Ethernet logical interface.
You can configure subscriber management services such as firewall filters and CoS for this subscriber interface.
To configure a subscriber interface using a static VLAN interface over an aggregated Ethernet logical interface:
- Configure the aggregated Ethernet interface.
- Configure the number of aggregated Ethernet interfaces
on the router.
See Configuring the Number of Aggregated Ethernet Interfaces on the Device.
- Configure the aggregated Ethernet interface.
- (Optional) Configure LACP.
- (Optional) Configure the minimum number of links.
- (Optional) Configure the link speed.
- (Optional) Configure the aggregated Ethernet logical interface
to support one-to-one active/backup link redundancy or traffic load
balancing.
See Configuring Aggregated Ethernet Link Protection.
Note: Link protection is required if you want to configure hierarchical CoS on the aggregated Ethernet interface. For more information, see Configuring Hierarchical CoS for a Subscriber Interface of Aggregated Ethernet Links.
- Configure the number of aggregated Ethernet interfaces
on the router.
- Configure the static or dynamic VLAN interface.
- For static VLAN interfaces, see Configuring Static Subscriber Interfaces in Dynamic Profiles.
- For dynamic VLAN interfaces, see Configuring VLAN Dynamic Profiles and Configuring VLAN Interfaces to Use Dynamic Profiles.
- Configure subscriber management services on the subscriber interface.
