Help us improve your experience.
Let us know what you think.
Do you have time for a two-minute survey?
Additional Comments
800 characters remaining
May we contact you if necessary?
This site is protected by hCaptcha and its Privacy Policy and Terms of Service apply.
Junos® OS Documentation for M, MX, PTX, and T Series Routers, Release 13.1
Tunnel Services Overview
GRE Keepalive Time Overview
Configuring Unicast Tunnels
Configuring GRE Keepalive Time
Restricting Tunnels to Multicast Traffic
Configuring Logical Tunnel Interfaces
Configuring Tunnel Interfaces for Routing Table Lookup
Configuring Virtual Loopback Tunnels for VRF Table Lookup
Configuring PIM Tunnels
Configuring IPv6-over-IPv4 Tunnels
Configuring Dynamic Tunnels
Configuring Tunnel Interfaces on MX Series Routers
Configuring Tunnel Interfaces on T4000 Routers
Examples: Configuring Unicast Tunnels
Example: Configuring a Virtual Loopback Tunnel for VRF Table Lookup
Example: Configuring an IPv6-over-IPv4 Tunnel
Example: Configuring Logical Tunnels
Example: Configuring Keepalive for a GRE Interface
allow-fragmentation
backup-destination
copy-tos-to-outer-ip-header
destination (Tunnel Remote End)
destination (Routing Instance)
destination-networks
do-not-fragment
dynamic-tunnels
hold-time (OAM)
interfaces
keepalive-time
key
multicast-only
peer-unit
reassemble-packets
routing-instance
routing-instances
routing-options
source
source-address
ttl
tunnel
unit (Interfaces)
show interfaces (GRE)
show interfaces (IP-over-IP)
show interfaces (Logical Tunnel)
show interfaces (Multicast Tunnel)
show interfaces (PIM)
show interfaces (Virtual Loopback Tunnel)
Juniper Knowledge Base
© 1999 - 2018 Juniper Networks, Inc. All rights reserved
