Supported Platforms
Related Documentation
- QFabric System, QFX Series standalone switches
- flow-control
- rx-buffers
- Enabling and Disabling CoS Symmetric Ethernet PAUSE Flow Control
- Configuring CoS Asymmetric Ethernet PAUSE Flow Control
- Understanding CoS Flow Control (Ethernet PAUSE and PFC)
tx-buffers
Syntax
Hierarchy Level
Release Information
Statement introduced in Junos OS Release 12.1 for the QFX Series.
Description
Enable or disable an interface to respond to received Ethernet PAUSE messages. If you enable the transmit buffers to respond to PAUSE messages, when the interface receives a PAUSE message from the connected peer, the interface stops transmitting frames on the entire link. When the receive buffer on the connected peer empties below a certain threshold, the peer interface sends a message to the paused interface to resume sending frames.
Ethernet PAUSE prevents buffers from overflowing and dropping packets during periods of network congestion. If the other devices in the network are also configured to support PAUSE, PAUSE supports lossless operation. Use the tx-buffers statement with the rx-buffers statement to configure asymmetric Ethernet PAUSE on an interface. (Use the flow-control statement to enable symmetric PAUSE and the no-flow-control statement to disable symmetric PAUSE on an interface. Symmetric flow control and asymmetric flow control are mutually exclusive features. If you attempt to configure both, the switch returns a commit error.)
![]() | Note: Ethernet PAUSE temporarily stops transmitting all traffic on a link when the buffers fill to a certain threshold. To temporarily pause traffic on individual “lanes” of traffic (each lane contains the traffic associated with a particular IEEE 802.1p code point, so there can be eight lanes of traffic on a link), use priority-based flow control (PFC). Ethernet PAUSE and PFC are mutually exclusive features, so you cannot configure both of them on the same interface. If you attempt to configure both Ethernet PAUSE and PFC on an interface, the switch returns a commit error. |
Default
Flow control is disabled. You must explicitly configure Ethernet PAUSE flow control on interfaces.
Options
on | off—Enable or disable an interface to respond to an Ethernet PAUSE message.
Required Privilege Level
interface—To view this statement in the
configuration.
interface-control—To add this
statement to the configuration.
Related Documentation
- QFabric System, QFX Series standalone switches
- flow-control
- rx-buffers
- Enabling and Disabling CoS Symmetric Ethernet PAUSE Flow Control
- Configuring CoS Asymmetric Ethernet PAUSE Flow Control
- Understanding CoS Flow Control (Ethernet PAUSE and PFC)
Published: 2014-07-23
Supported Platforms
Related Documentation
- QFabric System, QFX Series standalone switches
- flow-control
- rx-buffers
- Enabling and Disabling CoS Symmetric Ethernet PAUSE Flow Control
- Configuring CoS Asymmetric Ethernet PAUSE Flow Control
- Understanding CoS Flow Control (Ethernet PAUSE and PFC)