Navigation
Enabling or Disabling SNMP Notifications on Physical Interfaces
By default, Simple Network Management Protocol (SNMP) notifications are sent when the state of an interface or a connection changes. You can enable or disable these notification based on you requirements.
To explicitly enable sending SNMP notifications on the physical interface, perform the following steps:
- In configuration mode, go to the [edit interfaces interface-name] hierarchy level:[edit]user@host# edit interfaces interface-name
- Configure the traps option to enable sending
of Simple Network Management Protocol (SNMP) notifications when the
state of the connection changes.[edit interfaces interface-name]user@host# set traps
To disable sending SNMP notifications on the physical interface, perform the following steps:
- In configuration mode, go to the [edit interfaces interface-name] hierarchy level:[edit]user@host# edit interfaces interface-name
- Configure the no-traps option to disable sending
of Simple Network Management Protocol (SNMP) notifications when the
state of the connection changes.[edit interfaces interface-name]user@host# set no-traps
 | Note: Gigabit Ethernet interfaces on J Series routers do not support SNMP. |
