Navigation
Table of Contents
Guide That Contains This Content
[+] Expand All
[-] Collapse All
Supported Platforms
Setting the SAToP Options
To configure SAToP options on T1/E1 interfaces:
- In configuration mode, go to the [edit interfaces e1-fpc-slot/pic-slot/port] hierarchy level.[edit]user@host# edit interfaces e1-fpc-slot/pic-slot/port
For example:
[edit]user@host# edit interfaces e1-1/0/0 - Use the edit command to go to the satop-options hierarchy level.[edit]user@host# edit satop-options
- In this hierarchy level, using the set command
you can configure the following SAToP options:
- excessive-packet-loss-rate—Set packet
loss options. The options are groups, sample-period, and threshold.
- groups—Specify groups.
- sample-period—Time required to calculate excessive packet loss rate (from 1000 through 65,535 milliseconds).
- threshold—Percentile designating the threshold of excessive packet loss rate (1–100 percent).
- idle-pattern—An 8-bit hexadecimal pattern to replace TDM data in a lost packet (from 0 through 255).
- jitter-buffer-auto-adjust—Automatically
adjust the jitter buffer.
Note: The jitter-buffer-auto-adjust option is not applicable on MX Series routers.
- jitter-buffer-latency—Time delay in the jitter buffer (from 1 through 1000 milliseconds).
- jitter-buffer-packets—Number of packets in the jitter buffer (from 1 through 64 packets).
- payload-size—Configure the payload size, in bytes (from 32 through 1024 bytes).
Note: In this section, we are configuring only one SAToP option. You can follow the same method to configure all the other SAToP options.
[edit interfaces e1-1/0/0 satop-options]user@host# set excessive-packet-loss-rate sample-period sample-periodFor example:
[edit interfaces e1-1/0/0 satop-options]user@host# set excessive-packet-loss-rate sample-period 4000 - excessive-packet-loss-rate—Set packet
loss options. The options are groups, sample-period, and threshold.
To verify this configuration, use the show command at the [edit interfaces e1-1/0/0] hierarchy level:
[edit interfaces e1-1/0/0]user@host# show
satop-options { excessive-packet-loss-rate {sample-period 4000;}}
