Navigation
Supported Platforms
Related Documentation
- QFabric System, QFX Series standalone switches
- Verifying the Status of a LAG Interface
- Example: Configuring Link Aggregation Between a QFX Series Product and an Aggregation Switch
Troubleshooting an Aggregated Ethernet Interface
Problem
Description: The show interfaces terse command shows that the LAG is down.
Solution
Check the following:
- Verify that there is no configuration mismatch.
- Verify that all member ports are up.
- Verify that a LAG is part of family ethernet-switching (Layer 2 LAG) or family inet (Layer 3 LAG).
- Verify that the LAG member is connected to the correct LAG at the other end.
- Verify that the LAG members belong to the same switch.
Related Documentation
- QFabric System, QFX Series standalone switches
- Verifying the Status of a LAG Interface
- Example: Configuring Link Aggregation Between a QFX Series Product and an Aggregation Switch
Published: 2014-07-23
Supported Platforms
Related Documentation
- QFabric System, QFX Series standalone switches
- Verifying the Status of a LAG Interface
- Example: Configuring Link Aggregation Between a QFX Series Product and an Aggregation Switch
