[ Contents] [ Prev] [ Next] [ Index] [ Report an Error]

power

Syntax

power -T target (-on | -off | -cycle | -state)

Release Information

Command supported by JUNOS Release 9.1 and later.

Description

(JCS management module CLI) Power on or power off a specified Routing Engine (blade) or JCS switch module. Alternatively, display the power setting for a specified Routing Engine or switch module.

Options

-T target—Specify the target of the power command. Valid targets for this command are:

system:blade[x]—Specify a Routing Engine as the command target. Replace x with the Routing Engine slot number (1 through 12)
system:switch[x]—Specify a JCS switch module as the command target. Replace x with the switch number (1 or 2).

-on—Turn on the specified Routing Engine or JCS switch module.

-off—Turn off the specified Routing Engine or JCS switch module.

-cycle—Cycle power for the specified Routing Engine or JCS switch module. If the Routing Engine or JCS switch module is off, it will turn on. If the Routing Engine or JCS switch module is on, it will turn off.

-state—Display the current power state (on or off) for the specified Routing Engine or JCS switch module.

Required Privilege Level

supervisor

List of Sample Output

power (On)
power (Cycle)
power (State)

Output Fields

When you enter this command, you are provided feedback on the status of your request.

Sample Output

power (On)

system> power –T system:switch[1] —on

OK

power (Cycle)

system> power –T system:switch[1] —cycle

Off

power (State)

system> power –T system:blade[3] —state

On