name—Name that identifies the regular expression. The name can contain letters, numbers, and hyphens (-) and can be up to 255 characters. To include spaces in the name, enclose it in quotation marks (“ ”).
invert-match—Invert the results of the community expression matching.
members community-ids—One or more community members. If you specify more than one member, you must enclose all members in brackets.
The format for community-ids is:
as-number is the AS number and can be a value in the range from 0 through 65,535. community-value is the community identifier and can be a number in the range from 0 through 65,535.
You also can specify community-ids for communities as one of the following well-known community names, which are defined in RFC 1997, BGP Communities Attribute:
- no-export—Routes containing this community name are not advertised outside a BGP confederation boundary.
- no-advertise—Routes containing this community name are not advertised to other BGP peers.
- no-export-subconfed—Routes containing this community name are not advertised to external BGP peers, including peers in other members' ASs inside a BGP confederation.
You can explicitly exclude BGP community information with a static route using the none option. Include none when configuring an individual route in the route portion of the static statement to override a community option specified in the defaults portion of the statement.
The format for extended community-ids is the following:
type is the type of extended community and can be either a bandwidth, target, origin, domain-id, src-as, or rt-import community or a 16-bit number that identifies a specific BGP extended community. The target community identifies the destination to which the route is going. The origin community identifies where the route originated. The domain-id community identifies the OSPF domain from which the route originated. The src-as community identifies the autonomous system from which the route originated. The rt-import community identifies the route to install in the routing table.
 |
Note: For src-as, you can specify only an AS number and not an IP address. For rt-import, you can specify only an IP address and not an AS number. |
administrator is the administrator. It is either an AS number or an IPv4 address prefix, depending on the type of extended community.
assigned-number identifies the local provider.
The format for linking a bandwidth with an AS number is:
bandwidth:as-number:bandwidth
as-number specifies the AS number and bandwidth specifies the bandwidth in bytes per second.
|
Note: In JUNOS Release 9.1 and later, you can specify 4-byte AS numbers as defined in RFC 4893, BGP Support for Four-octet AS Number Space, as well as the 2-byte AS numbers that are supported in earlier releases of the JUNOS software. In plain-number format, you can configure a value in the range from 1 through 4,294,967,295. To configure a target or origin extended community that includes a 4-byte AS number in the plain-number format, append the letter “L” to the end of number. For example, a target community with the 4-byte AS number 334,324 and an assigned number of 132 is represented as target:334324L:132. In JUNOS Release 9.2 and later, you can also use AS-dot notation when defining a 4-byte AS number for the target and origin extended communities. Specify two integers joined by a period: 16-bit high-order value in decimal.16-bit low-order value in decimal. For example, the 4-byte AS number represented in plain-number format as 65546 is represented in AS-dot notation as 1.10. For more information about configuring AS numbers, see the JUNOS Routing Protocols Configuration Guide. |