Each Services Router supports multiple types of interfaces that perform different functions. The router uses DS1, DS3, Fast Ethernet, Gigabit Ethernet, and serial network interfaces to transmit and receive network traffic. For network interfaces to operate, you must configure properties such as logical interfaces, the encapsulation type, and certain settings specific to the interface type.
In most cases, you can use either J-Web Quick Configuration or a configuration editor to configure network interfaces.
 |
Note: You cannot configure channelized T1 or E1 interfaces through a J-Web Quick Configuration page. You must use the J-Web or CLI configuration editor. Even after configuration, channelized interfaces do not appear on the Quick Configuration Interfaces page. |
This chapter includes the following topics. For more information about interfaces, see Interfaces Overview and the JUNOS Network Interfaces Configuration Guide. To configure channelized interfaces, see Configuring Channelized T1/E1/ISDN PRI Interfaces. To configure DSL interfaces, see Configuring Digital Subscriber Line Interfaces. To configure PPPoE interfaces, see Configuring Point-to-Point Protocol over Ethernet. To configure ISDN interfaces, see Configuring ISDN.