To verify that a device is configured for autoinstallation, perform the following task.
Display the status of the autoinstallation feature on a device.
From the CLI, enter the show system autoinstallation status command.
user@host> show system autoinstallation
status
Autoinstallation status:
Master state: Active
Last committed file: None
Configuration server of last committed file: 10.25.100.1
Interface:
Name: ge-0/0/0
State: Configuration Acquisition
Acquired:
Address: 192.168.124.75
Hostname: host-ge-000
Hostname source: DNS
Configuration filename: router-ge-000.conf
Configuration filename server: 10.25.100.3
Address acquisition:
Protocol: DHCP Client
Acquired address: None
Protocol: RARP Client
Acquired address: None
Interface:
Name: ge-0/0/1
State: None
Address acquisition:
Protocol: DHCP Client
Acquired address: None
Protocol: RARP Client
Acquired address: None
The output shows the settings configured for autoinstallation. Verify that the values displayed are correct for the device when it is deployed on the network.