CLI Configuration

To set the node IDs and cluster IDs, connect to each Services Router through the console port and enter the following operational commands, then reboot the system.

• Enter the cluster ID and node ID information for the first node. If you want redundancy groups to be primary on this node when priority settings for both nodes are the same, make it node 0.

  user@host> set chassis cluster node 0 cluster-id 1

  warning: A reboot is required for chassis cluster to be enabled

• Enter the cluster ID and node ID for the other node. If you want redundancy groups to be secondary on this node when priority settings for both nodes are the same, make it node 1.

  user@host> set chassis cluster node 1 cluster-id 1 reboot

  Successfully enabled chassis cluster. Going to reboot now.

After you set the cluster ID and node ID for each node and the system reboots, the built-in interfaces are automatically renamed (see Table 53). Use the show chassis cluster status operational command to view node status.

Cluster ID: 3
Node name                  Priority     Status    Preempt  Manual failover

Redundancy group: 0 , Failover count: 1
    node0                   254         Secondary No       No
    node1                   2           Primary   No       No

Redundancy group: 1 , Failover count: 1
    node0                   101         Secondary No       No
    node1                   99          Primary   No       No

When you complete the chassis cluster basic configuration, any subsequent configuration changes you make are automatically synchronized on both nodes.