- play_arrow Planning
- play_arrow System Specifications
- play_arrow Planning and Preparing the Site
- play_arrow Cable and Pinout Specifications
- Cable Specifications for Console Connections for the CTP151 Device
- Mini-USB Type-B Console Port Specifications for a CTP151 Device
- Console Port Connector Pinouts for a CTP151 Device
- USB Port Specifications for a CTP151 Device
- Management Port Connector Pinout Information for the CTP151 Device
- Network Port Connector Pinout Information for a CTP151 Device
- RJ-45 to DB-9 Serial Port Adapter Pinout Information for a CTP151 Device
- CTP151 Interface Module HD-26 Connector Cable Pinouts
-
- play_arrow Safety
- play_arrow General Safety Guidelines and Warnings
- play_arrow Module Installation Safety Guidelines and Warnings
- play_arrow Hardware Compliance and Homologation
-
- play_arrow Installation
- play_arrow Unpacking and Mounting the CTP151 Device
- play_arrow Installing Modules
- play_arrow Cabling
-
- play_arrow Configuration
- play_arrow Accessing the CTP151 Platform
- play_arrow Powering On and Initially Configuring the CTP151 Device
-
- play_arrow Maintenance
- play_arrow Maintaining Components
- play_arrow Product Reclamation and Recycling
- play_arrow Contacting Customer Support and Returning the Chassis or Components
-
- play_arrow Troubleshooting
- play_arrow Troubleshooting Hardware and Power Failures
-
Power Supply in the CTP151 Device
The CTP151 device uses a fixed, internal AC power supply. The power supply distributes different output voltages to the device components according to their voltage requirements. The power supply is fixed in the chassis and is not field-replaceable.
The power supply has a single AC appliance inlet that requires a dedicated AC power feed. The AC power cord inlet is on the rear panel of the device.
Table 1 describes the AC power specifications for a CTP151 device.
AC Input Voltage (Operating Range) | AC Input Line Frequency | AC Input Current Rating | Maximum Power Consumption | Power Supply Type |
|---|---|---|---|---|
100–240 VAC | 50–60 Hz nominal | 1.8 A maximum | 150 W | Internal |
A detachable AC power cord is supplied with the AC power supplies. The coupler is type C13 as described by International Electrotechnical Commission (IEC) standard 60320. The plug end of the power cord fits into the power source outlet that is standard for your geographical location.
The AC power cord provided with each power supply is intended for use with that power supply only and not for any other use.
In North America, AC power cords must not exceed 4.5 meters in length, to comply with National Electrical Code (NEC) Sections 400-8 (NFPA 75, 5-2.2) and 210-52 and Canadian Electrical Code (CEC) Section 4-010(3). The cords supplied with the switch are in compliance.
