- play_arrow Overview
- play_arrow Site Planning, Preparation, and Specifications
- play_arrow Maintaining Components
- play_arrow Troubleshooting Hardware
- play_arrow Contacting Customer Support and Returning the Chassis or Components
- play_arrow Safety and Compliance Information
- General Safety Guidelines and Warnings
- Definitions of Safety Warning Levels
- Restricted Access Warning
- Fire Safety Requirements
- Qualified Personnel Warning
- Warning Statement for Norway and Sweden
- Installation Instructions Warning
- Chassis and Component Lifting Guidelines
- Ramp Warning
- Rack-Mounting and Cabinet-Mounting Warnings
- Grounded Equipment Warning
- Laser and LED Safety Guidelines and Warnings
- Radiation from Open Port Apertures Warning
- Maintenance and Operational Safety Guidelines and Warnings
- General Electrical Safety Guidelines and Warnings
- Prevention of Electrostatic Discharge Damage
- AC Power Electrical Safety Guidelines
- AC Power Disconnection Warning
- DC Power Disconnection Warning
- DC Power Grounding Requirements and Warning
- DC Power Wiring Sequence Warning
- DC Power Wiring Terminations Warning
- Multiple Power Supplies Disconnection Warning
- TN Power Warning
- Action to Take After an Electrical Accident
- JRR200 Agency Approvals and Regulatory Compliance Information
Unpacking the JRR200
Unpacking the JRR200 Route Reflector
The JRR200 Route Reflector is shipped in a cardboard carton, secured with foam packing material. The carton also contains an accessory box and quick-start instructions.
The JRR200 route reflector is maximally protected inside the cardboard carton. Do not unpack it until you are ready to begin installation.
To unpack the JRR200 route reflector:
- Move the cardboard carton to a staging area as close to the installation site as possible, where you have enough room to remove the components from the chassis.
- Open the carton.
- Pull out the packing material holding the JRR200 route reflector in place.
- Verify the parts received against the inventory (packing list). The packing list specifies the part numbers and carries a brief description of each part in your order.
- Save the shipping carton and packing materials in case you need to move or ship the JRR200 route reflector at a later time.
Verifying Parts Received with the JRR200 Route Reflector
A packing list is included in each shipment. Check the parts in the shipment against the items on the packing list. The packing list specifies the part numbers and descriptions of each part in your order.
If any part on the packing list is missing, contact your customer service representative or contact Juniper customer care from within the U.S. or Canada by telephone at 1-888-314-5822. For international-dial or direct-dial options in countries without toll-free numbers, see https://www.juniper.net/support/requesting-support.html .
The parts shipped with your JRR200 route reflector can vary depending on the configuration you ordered.
Table 1 lists the parts and their quantities in the packing list.
Component | Quantity |
|---|---|
Route reflector | 1 |
Power supply (pre-installed) | 2 AC or DC |
AC power cord appropriate for your geographical location (only for AC models) | 2 |
Rack mount kit | 1 |
Quick Start installation instructions | 1 |
Juniper Product ROHS and Warranty Document | 1 |
End User License Agreement | 1 |
Safety Guide | 1 |
RJ-45 to DB-9 serial port adapter | 1 |
RJ-45 cables | 2 |
