- play_arrow Fast Track: Initial Installation
- play_arrow Overview
- play_arrow Site Planning, Preparation, and Specifications
- play_arrow Initial Installation and Configuration
- MX10004 Installation Overview
- Unpack the MX10004 Router
- Mount the Juniper Networks MX10004 Router Using the JNP10004-RMK-4POST Rack-Mount Kit
- Mount the Juniper Networks MX10004 Router Using the JNP10K-RMK-4PST-XT Rack-Mount Kit
- Install the Front Door on an MX10004 Router
- Connect the MX10004 to Power
- Connect the MX10004 Router to External Devices
- Register Products—Mandatory to Validate SLAs
- Perform the Initial Configuration for the MX10004 Router
- play_arrow Maintaining Components
- play_arrow Troubleshooting the MX10004 Router
- play_arrow Contacting Customer Support and Returning the Chassis or Components
Ramp Warning
When installing the device, do not use a ramp inclined at more than 10 degrees.
Waarschuwing Gebruik een oprijplaat niet onder een hoek van meer dan 10 graden.
Varoitus Älä käytä sellaista kaltevaa pintaa, jonka kaltevuus ylittää 10 astetta.
Avertissement Ne pas utiliser une rampe dont l'inclinaison est supérieure à 10 degrés.
Warnung Keine Rampen mit einer Neigung von mehr als 10 Grad verwenden.
Avvertenza Non usare una rampa con pendenza superiore a 10 gradi.
Advarsel Bruk aldri en rampe som heller mer enn 10 grader.
Aviso Não utilize uma rampa com uma inclinação superior a 10 graus.
¡Atención! No usar una rampa inclinada más de 10 grados.
Varning! Använd inte ramp med en lutning på mer än 10 grader.