MX2000 AC Power Cord Specifications

Most sites distribute power through a main conduit that leads to frame-mounted power distribution panels, one of which can be located next to the rack that houses the router. An AC power cord connects each power distribution module (PDM) to the power distribution panel. Detachable AC power cords are supplied with the router. For single–phase PDMs, the coupler type is C21. For three-phase power, the power cord wires are inserted into the AC input terminal with the help of a screwdriver. The plug end of the power cord fits into the power source receptacle for your geographical location.

For more information about AC PDM input power mapping, see Mapping Input Power from AC Power Distribution Modules to AC Power Supply Modules on MX2000 Routers.

CAUTION:

In North America, AC power cords must not exceed approximately 14.75 ft (4.5 m) in length, to comply with National Electrical Code (NEC) Sections 400-8 (NFPA 75, 5-2.2) and 210-52, and Canadian Electrical Code (CEC) Section 4-010(3). The cords supplied with the router are in compliance.

CAUTION:

The router is pluggable type A equipment installed in a restricted-access location. It has a separate protective earthing terminal (sized for UNC 1/4-20 ground lugs) provided on the chassis in addition to the grounding pin on the power cord. This separate protective earthing terminal must be permanently connected to earth.

CAUTION:

Power cords and cables must not block access to device components or drape where people could trip on them.

Note:

Three-phase power cords provided with the router are approximately 14.75 ft (4.5 m) in length. Single–phase power cords provided with the router are approximately 8.2 ft (2.5 m) in length.

Table 1 and Table 2 provide specifications for the AC power cords for each region supported. Figure 1 and Figure 2 illustrate the plug on the three-phase Delta and Wye AC power cords.

Table 1: Three-Phase Delta and Wye AC Power Cord Specifications
Region	Model Number
North America	CBL-MX2000-3PH-DELTA
Europe	CBL-MX2000-3PH-WYE

Figure 1: Three-Phase Delta AC Power Cord

Figure 2: Three-Phase Wye AC Power Cord

Table 2: Single-Phase AC Power Cord Specifications
Region	Model Number	Electrical Specification	Plug Type
Australia	CBL-PWR-C21S-AU	15 A @ 250 VAC	AS/NZS 3112
China	CBL-PWR-C21S-CH	16 A @ 250 VAC	GB 1002/GB 2099
Europe	CBL-PWR-C21S-EU	16 A @ 250 VAC	CEE (7) VII
International	CBL-PWR-C21S-INTL	16 A @ 250 VAC	IEC60309
Italy	CBL-PWR-C21S-IT	16 A @ 250 VAC	CEI 23-50
Japan	CBL-PWR-C21S-JP	15 A @ 250 VAC	(NEMA) L6-20 Japan
US/Canada	CBL-PWR-C21S-US	20 A @ 250 VAC	(NEMA) L6-20

MX2000 AC Power Cord Specifications

Related Documentation