- play_arrow Overview
- play_arrow Site Planning, Preparation, and Specifications
- play_arrow Initial Installation and Configuration
- play_arrow Maintaining Components
- play_arrow Troubleshooting Hardware
- play_arrow Contacting Customer Support and Returning the Chassis or Components
- play_arrow Safety and Compliance Information
- General Safety Guidelines and Warnings
- Definitions of Safety Warning Levels
- Restricted Access Warning
- Qualified Personnel Warning
- Prevention of Electrostatic Discharge Damage
- Fire Safety Requirements
- Laser and LED Safety Guidelines and Warnings
- Radiation from Open Port Apertures Warning
- Maintenance and Operational Safety Guidelines and Warnings
- General Electrical Safety Guidelines and Warnings
- AC Power Electrical Safety Guidelines
- DC Power Electrical Safety Guidelines
- DC Power Disconnection Warning
- DC Power Grounding Requirements and Warning
- DC Power Wiring Sequence Warning
- DC Power Wiring Terminations Warning
- Action to Take After an Electrical Accident
- Agency Approvals
- Acoustic Noise Compliance Statements
- EMC Requirements
ON THIS PAGE
Fast Track to Rack Installation and Power
This procedure guides you through the simplest steps to install your SRX4200 Firewall in a rack and connect it to power. Have more complex installation needs? See Installing the SRX4200 Firewall in a Rack.
Install the SRX4200 in a Rack
Before you install, review the following:
- Attach the mounting ears to the front of the chassis and the fixed brackets
to the rear of the device.
- Slide the device into the rack, and secure the mounting ears to the
rack.
- Slide the adjustable brackets into the fixed brackets attached to the rear
of the device.
- Secure the adjustable brackets to the rack, using the mounting
screws.
Connect to Power
To connect the SRX4200 Firewall to AC power, you must do the following:
Ground the SRX4200 Firewall
To ground the SRX4200 Firewall, do the following:
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and connect the other end of the ESD strap to the ESD point on the rack.
Attach a grounding cable to earth ground, and then attach the other end to the grounding point at the rear of the SRX4200.
Connect the Power Cord and Power On the Firewall
To connect the power cord, do the following:
Ensure that the power supplies are fully inserted in the chassis and the latches are secure.
Plug the power cord into the power inlet on the rear panel of the SRX4200.
Push the power cord retainer onto the power cord.
If the AC power source outlet has a power switch, turn it off.
Plug the power cord into an AC power source outlet.
If the AC power source outlet has a power switch, turn it on. The firewall doesn't have a power switch and powers on as soon as you plug it in.
