Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

 
 

Update Pristine Config from Device

  1. From the blueprint, unassign the device by removing the system ID (Staged > Physical > Build > Devices). Make sure the device is in the out of service state (OOS-READY or OOS-MAINT).
  2. Make any necessary changes to the running device configuration via CLI.
  3. From the left navigation menu in the Apstra GUI, navigate to Devices > Managed Devices and click the Management IP of the device to edit.
  4. Click the Pristine Config tab (top-left), then click the Update From Device button (top-right).
  5. Click Update to update Pristine Config from the device.

Verify the Pristine Config. You have copied the running config of the device in the out of service state, which should be Discovery 1 config. It may include additional configuration such as interface "speed" commands. You can edit Pristine Config again and delete the additional configuration manually. Contact Juniper Support for assistance as needed.