close
keyboard_arrow_left
Table of Contents
- play_arrow Overview
- play_arrow Using Bundles to Create Logical Configurations for Physical Interfaces Overview
- play_arrow CTP Bundle Overview
- Adaptive Clocking Overview for CTP Bundles
- Determining Optimal Packet Size for CTP Bundles Overview
- Providing QoS for CTP Bundles by Using Service Type Overview
- Circuit Startup Process Overview
- Network Node Reference Overview
- Support for Multiple Primary Nodes to Associate With a Single Member Node in NetRef
- Loss of Signal Detection Capability on CTP Bundles and SAToP Bundles
- Guidelines for Configuring LOS Detection
- play_arrow Transparent Encoding Overview
- play_arrow TDM/TDC Encoding Overview
- play_arrow Ethernet Media Configuration Overview
-
- play_arrow Administration
- play_arrow Activating, Disabling, Deleting, or Recentering CTP Bundles
- play_arrow Querying CTP Bundles
- play_arrow Monitoring Packet Creation and Reception and Packet Delay
- play_arrow Diagnostic Testing for CTP Bundles Overview
- play_arrow Configuring and Displaying Diagnostic Testing for CTP Bundles
- Configuring Serial Loops for CTP Bundles (CTP Menu)
- Configuring Serial Loops for CTP Bundles (CTPView)
- Configuring BERT Testing for CTP Bundles (CTP Menu)
- Configuring BERT Testing for CTP Bundles (CTPView)
- Displaying BERT Status and Counters for CTP Bundles (CTP Menu)
- Displaying BERT Status and Counters for CTP Bundles (CTPView)
- play_arrow Reducing the Number of SNMP Traps Generated for Late and Missing Packets
-
- play_arrow Troubleshooting
- play_arrow Knowledge Base
-
list Table of Contents
Configuring the Direction of the Circuit (CTPView)
date_range
26-May-23
This topic describes how to configure the direction of the circuit.
Before you begin:
Log in to the CTPView software at least at the Net_Admin level.
Connect the CTPView server to the CTP device for which you want to configure bundles.
To configure the direction of circuits created with the CTP bundle using CTPView:
- In the side pane, select Bundle > Configuration.
- Run your mouse over the Display and Select an Existing Bundle bar.
- In the table of bundles, select the bundle that you want to modify.
- Under Bundle Options, configure the parameters as described in Table 1 and click Click to Submit Bundle AND Port Changes.
| Field | Function | Your Action |
|---|---|---|
Unidirectional Circuit | Specifies whether the circuit is unidirectional or bidirectional. If unidirectional, specify the direction of the circuit—source or destination. | Select one:
|
