Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

 
 

Configuring NTP over IPv6 on CTPView Server (CTPView)

Following are the pre-requirements for configuring NTP over IPv6 on CTPView:

  • CTPView should be configured to either “IPv6 only” or “IPv4 and IPv6” protocol as shown below:

  • The NTP server should be configured with an IPv6 address.

Configuring NTP over IPv6 on CTPView

To configure NTP over IPv6 on CTPView:

  1. In the side pane, select Server > Administration. The Administrative Functions pane is displayed.
  2. Click NTP Server Configuration. The NTP Server Settings window is displayed.
  3. Under the Manage NTP Peers section, enter the IPv6 address of NTP server, and then click Add New NTP Peer.

    A popup of “Successfully added peer” is displayed.

  4. Click OK and wait for 3 to 5 minutes. Then, click Refresh Page.

    Under the Summary of NTP Servers Peers section, verify that the CTPView server is synchronized successfully with the added NTP server.

  5. You can also manually synchronize CTPView server with NTP server by selecting the already added NTP peer from the Select a peer to manually sync to: list and then clicking the Sync to Selected Peer button.

    After clicking Sync to Selected Peer, a popup of “The CTPView server clock has been manually synchronized to peer” should be displayed. Wait for 3 to 5 minutes, and then click the Refresh Page button. Under the Summary of NTP Servers Peers section, verify that CTPView server is synchronized successfully with the added NTP server.