- play_arrow Overview
- play_arrow Multiservice Interface Module Overview
-
- play_arrow Troubleshooting
- play_arrow Knowledge Base
-
Configuring Multiservice TDC Mode Parameters for CTP Bundles (CTPView)
Before you begin:
Log in to the CTPView software at least at the Net_Admin level.
Connect the CTPView server to the CTP device for which you want to configure bundles.
To configure Multiservice TDC mode port parameters using CTPView:
- In the side pane, select Bundle > Configuration.
- Run your mouse over the Display and Select an Existing Bundle bar.
- In the table of bundles, select the bundle that you want to modify.
- Under Bundle Options, configure the parameters as described in Table 1 and click Click to Submit Bundle AND Port Changes.
| Field | Function | Your Action |
|---|---|---|
Port Description | Specifies a description for the port. | Enter a description of up to 64 alphanumeric characters. Do not use the following characters: ( ; ' " ) ] |
I/F Type | Specifies the daughter card as the interface type. | Select DCARD. |
Multi-Service Mode | Specifies that the bundle will run in TDC mode. | Select TDC. |
TDC Source | Specifies the direction of the circuit. | Select one:
|
TDC NRZ Rate | Specifies the NRZ data rate on the IP connection. | Enter a number from 500 through 5,000,000 bps in multiples of 500. |
TDC IRIG Output Level | Specifies the output level. Note the following information about the values:
| Enter a number from 0 through 255. |
