Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

 
 

Configuring 2W-FXO Port Parameters for VComp Bundles (CTPView)

This topic describes how to configure port parameters for 2W-FXO interfaces.

Before you begin:

  • Log in to the CTPView software at least at the Net_Admin level.

  • Connect the CTPView server to the CTP device for which you want to configure bundles.

  • Disable the bundle before you modify the bundle options.

To configure port parameters for 2W-FXO interfaces using CTPView:

  1. In the side pane, select Bundle > Configuration.
  2. Run your mouse over the Display and Select an Existing Bundle bar.
  3. In the table of bundles, select the bundle that you want to modify.
  4. Under Port Options, configure the parameters described in Table 1.
  5. Click Click to Submit Bundle AND Port Changes.
Table 1: VComp Bundle 2W-FXO Port Parameter Settings in CTPView
Field Function Your Action

Voice Port Tx Gain

[ -15.0 to 10.4 dB ]

Specifies the gain in the direction from the analog interface toward the IP network.

Select a dB value from the list.

Voice Port Rx Gain

[ -15.0 to 10.4 dB ]

Specifies the gain in the direction from the IP network to the analog interface.

Select a dB value from the list.

Voice Port Signaling

Specifies the type of analog signaling used.

Select one:

  • ground start—Typically used between a central office (CO) and a PBX to prevent glare. Glare occurs when the FXS device establishes a call and the FXO device attempts to make a call before the ring is detected.

  • loop start—Typically used for residential phones.

Voice Port PLAR

Private line automatic ringdown (PLAR) is not supported on FXO interfaces.

Not supported

Related Documentation