Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

 
 

HPE ProCurve

You can integrate an HPE ProCurve device with JSA to record all relevant HPE Procurve events using syslog.

Take the following steps to configure your HPE ProCurve device to forward syslog events to JSA.

  1. Log into the HPE ProCurve device.

  2. Type the following command to make global configuration level changes.

    config

    If successful, the CLI will change to the following prompt:

    ProCurve(config)#

  3. Type the following command:

    logging <syslog-ip-addr>

    Where: <syslog-ip-addr> is the IP address of JSA.

  4. To exit config mode, press CTRL+Z.

  5. Type the following command: write mem to save the current configuration to the startup configuration for your HPE ProCurve device.

    You are now ready to configure the log source in JSA.

Syslog Log Source Parameters for HPE ProCurve

If JSA does not automatically detect the log source, add an HPE ProCurve log source on the JSA Console by using the syslog protocol.

When using the syslog protocol, there are specific parameters that you must use.

The following table describes the parameters that require specific values to collect syslog events from HPE ProCurve:

Table 1: Syslog Log Source Parameters for the HPE ProCurve DSM

Parameter

Value

Log Source Name

Type a name for your log source.

Log Source Description

Type a description for the log source.

Log Source type

HP ProCurve

Protocol Configuration

Syslog

Log Source Identifier

Type the IP address or host name for your HPE ProCurve appliance.