gtp-header-offset

Syntax

Hierarchy Level (QFX5000 line of switches)

Description

You must only provide a decimal value for gtp-header-offset command. As per standards, 0x32 is the default header offset value. But, due to some special patterns in the header, offset may vary like, 0x30, 0x28, and so on. In this case, you need to convert it to a proper offset value as follows:

For Example:

• If the offset value is 0x32, the equivalent decimal value is calculated as (16*3+2) which is equal to 50.

• If the offset value is 0x30, the equivalent decimal value is calculated as (16*3+0) which is equal to 48.

After setting gtp-header-offset to a proper offset value, run gtp-tunnel-endpoint-identifier command to enable GTP hashing. Refer gtp-tunnel-endpoint-identifier for more details. For example:

• If the IPv6 traffic has 0x32 as offset value, then use set forwarding-options enhanced-hash-key family inet gtp-tunnel-endpoint-identifier command directly.

• If the IPv6 traffic has 0x30 as offset value, then you must set proper offset value after enabling GTP hashing as follows:

  set forwarding-options enhanced-hash-key family inet gtp-tunnel-endpoint-identifier

  set forwarding-options enhanced-hash-key hash-mode gtp-header-offset 48

• If the IPv4 traffic has 0x32 as offset value, then use set forwarding-options enhanced-hash-key family inet gtp-tunnel-endpoint-identifier command directly.

• If the IPv4 traffic has 0x30 as offset value, then you must set proper offset value after enabling GTP hashing as follows:

  set forwarding-options enhanced-hash-key family inet gtp-tunnel-endpoint-identifier

  set forwarding-options enhanced-hash-key hash-mode gtp-header-offset 48

Required Privilege Level

interface—To view this statement in the configuration.

interface-control—To add this statement to the configuration.

Release Information

Statement introduced in Junos OS Release 17.3R3.