[OBSOLETE] ENABLE (DTCP)
Syntax
ENABLE DTCP/0.8 Csource-ID: user-name Criteria-ID: variable X-Drop-Policy: variable Flags: flags
Description
Specify the DTCP attributes used in ENABLE messages to cause the router to trigger a drop policy if one does not already exist from a prior DTCP ADD or DTCP ENABLE command.
The DTCP ENABLE message can only be issued on a Criteria-ID that was returned in a response to a previous DTCP ADD command. The policy applies to any new subscribers who match the trigger corresponding to the Criteria-ID. Any existing mirroring remains in place and the policy is not be applied to them. The DTCP ENABLE command stops only the traffic that is identified by the specified policy from being sent to the mediation device.
This DTCP message is supported for the radius-flow-tap service. It is not supported for the FlowTapLite service.
Consult the documentation for your mediation device to learn how to configure DTCP messages on the device.
Options
| Csource-ID: user-name | Username on the router. This username must be configured
as a DTCP user on the router using the |
| Criteria-ID: variable | Value returned from a prior DTCP ADD that identifies the trigger on which to disable this drop policy. |
| Flags: flag | STATIC is the only flag supported. |
| X-Drop-Policy: variable | Name of the policy that determines which mirrored packets are no longer sent to the mediation device. |
Required Privilege Level
Not applicable.
Sample Output
command-name
ENABLE DTCP/0.8 Csource-ID: ft-user1 Criteria-ID: 1 X-Drop: T1 Flags: STATIC Seq: 1 Authentication-Info: c16d2d9d1679facf0c4a66683af6114d341e4033 DTCP/0.8 200 OK SEQ: 7 CRITERIA-ID: 2 TIMESTAMP: 2011-02-13 15:56:49.609
Release Information
Command introduced in Junos OS Release 12.3.