Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

 
 

Configuring Static Routing (J-Web Procedure)

You can use the J-Web interface to configure static routes for EX Series switches.

To configure static routes:

  1. Select Configure > Routing > Static Routing. The Static Routing page displays details of the configured routes.
    Note:

    After you make changes to the configuration on this page, you must commit the changes for them to take effect. To commit all changes to the active configuration, select Commit Options > Commit. See Using the Commit Options to Commit Configuration Changes for details about all commit options.

  2. Click one of the following options:

    • Add—To configure a route. Enter information into the routing page as described in Table 1.

    • Edit—To modify an existing route. Enter information into the routing page as described in Table 1.

    • Delete—To delete an existing route.

Table 1: Static Routing Configuration Summary

Field

Function

Your Action
Default Route  

Default Route

Specifies the default gateway for the switch.

Note:

IPv6 is not supported on EX2200 and EX4500 switches.

To specify an IPv4 address:

  1. Select IPv4.

  2. Type an IP address—for example, 10.10.10.10.

  3. Enter the subnet mask or address prefix. For example, 24 bits represents 255.255.255.0.

To specify an IPv6 address:

  1. Select IPv6.

  2. Type an IP address—for example, 2001:ab8:85a3::8a2e:370:7334.

  3. Enter the subnet mask or address prefix.

Static Routes  

Nexthop

Specifies the next-hop address or addresses to be used when routing traffic to the static route.

To add an address:

  1. Click Add.

  2. In the IP address dialog, enter the IP address.

    Note:

    If a route has multiple next-hop addresses, traffic is routed across each address in round-robin fashion.

  3. Click OK.

To delete a next-hop address, select it from the list and click Delete.

Related Documentation