Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

 
 

Edit an IPsec VPN

You are here: VPN > IPsec VPN.

You can edit any of the following IPsec VPNs:

  • Site-to-Site VPN

  • Remote Access VPN (Juniper Secure Connect)

  • Remote Access VPN (NCP Exclusive Client)

To edit IPsec VPN:

Note:

  • When the IKE status is up and if you edit the IPsec VPN, the topology diagram is shown in green.

  • All local gateway protected networks will form traffic selectors with all remote gateway protected networks and vice-versa.

  1. Select an existing IPsec VPN configuration that you want to edit on the IPsec VPN page.
  2. Click the pencil icon available on the upper right-side of the page.

    The edit page for the selected IPsec VPN page appears with editable fields. You can modify any previous changes done to Site-to-Site VPN, Remote Access VPN (Juniper Secure Connect), and Remote Access VPN (NCP Exclusive Client).

  3. Click OK to save the changes. If you want to discard your changes, click Cancel.
Note:

  • During edit, Auto-create Firewall Policy and Gateway behind NAT options are not supported. Gateway behind NAT is supported only for remote access VPN.

  • The Source NAT Traffic option is only supported when creating remote access VPN. During edit, this option is not supported.

  • For Site-to-Site VPN, when the routing mode is Traffic Selector, the traffic selector creates the complete mesh between the local and remote addresses.

Related Documentation