Help us improve your experience.
Let us know what you think.
Do you have time for a two-minute survey?
Additional Comments
800 characters remaining
May we contact you if necessary?
This site is protected by hCaptcha and its Privacy Policy and Terms of Service apply.
Junos® OS Documentation for ACX, M, MX, PTX, and T Series Routers, Release 12.3
Configuring Channelized T3 IQ Interfaces
Configuring Channelized DS3-to-DS0 Interfaces
Configuring Channelized DS3-to-DS1 Interfaces
Configuring the Junos OS to Enable Channelization on DS3/E3 MIC
Configuring the Channelized T3 Loop Timing
Example: Configuring Channelized T3 IQ Interfaces
Examples: Configuring Channelized DS3-to-DS0 Interfaces
Examples: Configuring Channelized DS3-to-DS1 Interfaces
[edit chassis] Hierarchy Level
[edit interfaces] Hierarchy Level
[edit logical-systems] Hierarchy Level
bert-algorithm
bert-error-rate
bert-period
byte-encoding
cbit-parity
channelization
ds0-options
fast-aps-switch
fcs
feac-loop-respond
framing (E1, E3, and T1 Interfaces)
idle-cycle-flag
interface-type (Interfaces)
invert-data
long-buildout
loopback (ADSL, DS0, E1/E3, SONET/SDH, SHDSL, and T1/T3)
no-partition
partition
start-end-flag
t1-options
t3-options
timeslots
show interfaces (Channelized DS3-to-DS0)
show interfaces (Channelized DS3-to-DS1)
show interfaces (Channelized T3 IQ)
show interfaces (T1 or E1)
show interfaces (Channelized T1 IQ)
show interfaces (T3 or E3)
Channelized OC Interface Operational Commands
Channelized T1 and T3 Interface Operational Mode Commands
Junos OS Operational Mode Commands
Interface Diagnostics
Juniper Knowledge Base
Investigating Interface Steps and Commands
Monitor Channelized DS3 Interfaces
Use Loopback Testing For Channelized DS3 Interfaces
Locate Channelized DS3 Alarms and Errors
Monitor Multichannel DS3 Interfaces
Use Loopback Testing for Multichannel DS3 Interfaces
Locate Multichannel DS3 Alarms and Errors
© 1999 - 2018 Juniper Networks, Inc. All rights reserved
