Help us improve your experience.
Let us know what you think.
Do you have time for a two-minute survey?
Additional Comments
800 characters remaining
May we contact you if necessary?
This site is protected by hCaptcha and its Privacy Policy and Terms of Service apply.
Junos® OS Documentation, Release 13.1 (This release supports T Series routers only)
T1 Interfaces Overview
Configuring T1 Physical Interface Properties
Configuring T1 BERT Properties
Configuring the T1 Buildout
Configuring T1 Byte Encoding
Configuring T1 CRC Error Major Alarm Thresholds
Configuring T1 CRC Error Minor Alarm Thresholds
Configuring T1 Data Inversion
Configuring the T1 Frame Checksum
Configuring the T1 Remote Loopback Response
Configuring T1 Framing
Configuring T1 Line Encoding
Configuring T1 Loopback Capability
Configuring the T1 Idle Cycle Flag
Configuring T1 Start and End Flags
Configuring Fractional T1 Time Slots
[edit interfaces] Hierarchy Level
[edit logical-systems] Hierarchy Level
bert-algorithm
bert-error-rate
bert-period
buildout (T1 Interfaces)
byte-encoding
crc-major-alarm-threshold
crc-minor-alarm-threshold
e1-options
fast-aps-switch
fcs
framing (E1, E3, and T1 Interfaces)
idle-cycle-flag
invert-data
line-encoding
loopback (ADSL, DS0, E1/E3, SONET/SDH, SHDSL, and T1/T3)
remote-loopback-respond
start-end-flag
t1-options
timeslots
show interfaces (T1, E1, or DS)
Junos OS Operational Mode Commands.
Interface Diagnostics
Juniper Knowledge Base
Investigating Interface Steps and Commands
Monitor T1 Interfaces
Use Loopback Testing for T1 Interfaces
Locate T1 Alarms and Errors
© 1999 - 2018 Juniper Networks, Inc. All rights reserved
