Help us improve your experience.
Let us know what you think.
Do you have time for a two-minute survey?
Additional Comments
800 characters remaining
May we contact you if necessary?
This site is protected by hCaptcha and its Privacy Policy and Terms of Service apply.
Junos OS Network Interfaces Library for Routing Devices
T3 Interfaces Overview
Configuring T3 Physical Interface Properties
Configuring T3 BERT Properties
Disabling T3 C-Bit Parity Mode
Configuring the T3 CSU Compatibility Mode
Configuring the T3 Frame Checksum
Configuring the T3 FEAC Response
Configuring the T3 Idle Cycle Flag
Configuring the T3 Line Buildout
Configuring T3 Loopback Capability
Configuring T3 HDLC Payload Scrambling
Configuring T3 Start and End Flags
Examples: Configuring T3 Interfaces
[edit interfaces] Hierarchy Level
[edit logical-systems] Hierarchy Level
bert-algorithm
bert-error-rate
bert-period
cbit-parity
compatibility-mode
e3-options
fast-aps-switch
fcs
feac-loop-respond
idle-cycle-flag
long-buildout
loopback (ADSL, DS0, E1/E3, SONET/SDH, SHDSL, and T1/T3)
payload-scrambler
start-end-flag
t3-options
show interfaces (T3 or E3)
Junos OS Operational Mode Commands.
Interface Diagnostics
Interface Diagnostics Operational Mode Commands
Diagnose a Suspected Hardware Problem with a T3 Interface
Diagnose a Suspected Circuit Problem
Juniper Knowledge Base
Investigating Interface Steps and Commands
Monitor T3 Interfaces
Use Loopback Testing for T3 Interfaces
Locate T3 Alarms and Errors
© 1999 - 2018 Juniper Networks, Inc. All rights reserved
