- play_arrow 以太网接口
- play_arrow 聚合以太网接口
- play_arrow 千兆以太网接口
- play_arrow 端口速度
- play_arrow 400ZR 和 400G OpenZR+ 光收发器
- play_arrow 100GbE、40GbE 和 10GbE 光收发器
- play_arrow 以太网接口监控和故障排除
- play_arrow 监控接口
- play_arrow 接口故障排除
-
Unused
Hierarchy Level
[edit chassis fpc slot-number pic pic-number port port-number] [edit interface interface-name]
Description
(PTX10003-80C and PTX10003-160C routers) While setting port
0 to 400-Gigabit Ethernet mode (using QSFP56-DD-400GBASE-LR8 optics),
the total bandwidth (speed x number-of-subports) of port
1 has to be less than 100G and port 2 has to configured as 'unused'.
When using port 4 as 400G, port 3 has to be configured with total
bandwidth and port 2 has to be configured 'unused'. Similarly, with
port 5, 9 using 400G, port 6, 8 respectively has to be configured
for less than 100G and port 7 should be configured as 'unused'. That
is, when a port is configured in 400-Gigabit ethernet mode, you cannot
configure speed of the adjacent port to be more then 100-Gbps, and
the middle port (2 between 0~4 or 7 between 5~9) must be set to unused.
To set a particular port to unused port, use unused CLI
command.
You cannot use port 1,3,6 and/or 7 of the same logical PIC.
(JNP10K-LC1201 on PTX10008 routers) To disable the specified physical port in a PIC. If you disable a port, no interfaces (channelized or non-channelized) are created for the port, irrespective of the port profile configuration configured on the port.
The edit chassis hierarchy is available in 20.2R1
Release on PTX10001-36MR. From 20.3R1 onwards you must use only the edit interfaceinterface-name hierarchy.
