ON THIS PAGE
Example: Configuring RSVP on the VPLS PE Router
This example shows how to configure RSVP on the VPLS PE router.
Requirements
Before you begin:
Before you begin, see Understanding Selective Stateless Packet-Based Services .
Configure the interfaces that will carry the VPLS traffic between the PE router and the CE devices. SeeExample: Configuring Routing Interfaces on the VPLS PE Router and Example: Configuring the Interface to the VPLS CE Device.
Create a VPLS routing instance on each PE router that is participating in the VPLS. See Example: Configuring the VPLS Routing Instance.
Configure an IGP on the PE routers to exchange routing information. See Example: Configuring OSPF on the VPLS PE Router.
Overview
This example describes how to enable RSVP for all connections that participate in the LSP on the PE1 router.
Configuration
Step-by-Step Procedure
To configure RSVP on the VPLS PE router:
- Configure the interface to the PE2 router for RSVP.content_copy zoom_out_map[edit ]user@host# set protocols rsvp interface t1-1/0/1.0
- Configure the loopback interface for RSVP.content_copy zoom_out_map[edit ]user@host# set protocols rsvp interface lo0.0
- If you are done configuring the device, commit the configuration.content_copy zoom_out_map[edit]user@host# commit
Verification
To verify the configuration is working properly, enter the show protocols command.
