Supported Platforms
QFabric System Operational Mode Commands
Table 1 summarizes the command line interface (CLI) commands that you can use to monitor and troubleshoot the QFabric system operations.
Table 1: QFabric System Operational Mode Commands
Task | Command |
|---|---|
Select the operating mode for the device. | |
Set the Interconnect device Flexible PIC Concentrator (FPC) offline or online for the QFabric system. | |
Log in to individual QFabric system components for device level troubleshooting. | |
Select an enhanced Director device to become the new primary device within a Director group. | |
Add a MAC range to the MAC pool assigned to the QFabric system. | |
Delete a MAC range from the MAC block assigned to the QFabric system. | |
Upgrade the software version of the QFabric system by using the nonstop software upgrade method (which preserves forwarding functionality during the upgrade and enables components to upgrade on a rotating basis). | |
Display information about the operating mode of the device. | |
Display the status of the data plane connections in the QFabric system. | |
Display the fabric management status of devices in your QFabric system. | |
Display the status of a nonstop software upgrade for a Node group. | |
Display all devices that belong to the QFabric system. | |
Display the Director devices that belong to a QFabric system Director group. | |
Display the services running on the Director group for the QFabric system. | |
Display the Interconnect devices that belong to a QFabric system. | |
Display the Node devices that belong to the QFabric system. | |
Display the Node groups and the corresponding Node devices that belong to the QFabric system. | |
Display the MAC addresses that belong to a QFabric system Director group. | |
Display the Director device that hosts the QFabric CLI session. | |
Display the system log messages in the specified file. |
