Navigation
Supported Platforms
Configuring the Multiservices DPC for PTSP
To configure the Multiservices Dense Port Concentrator (MS-DPC) to support PTSP services, perform the following tasks:
Enabling the PTSP Service Package on the Multiservices DPC
The PTSP feature runs on the Multiservices DPC, you must enable the PTSP service package on the Multiservices DPC before you can configure the PTSP software. The name of the PTSP service package is jservices-ptsp.
To enable the PTSP service package:
- Determine the FPC slot number and the PIC number of the
MS-DPC on which you want to enable the PTSP service package. user@host> show chassis hardware
In this example, the FPC slot number is 3 and the PIC number is 0.
- Enable the jservices-ptsp package on the Multiservices
DPC. [edit chassis]user@host# set fpc 3 pic 0 adaptive-services service-package extension-provider package jservices-ptsp
Configuring Services Interface for PTSP
 | Note: ams- interfaces and rms- interfaces can be configured for PTSP. |
To configure the services interface for PTSP:
- Enter edit mode for the interface.[edit]user@host# edit interfaces ms-3/0/0
- Configure a logical unit and specify the protocol family.[edit interfaces ms-3/0/0]user@host# set unit 0 family inet
