TechLibrary

Navigation

Supported Platforms

Use the monitoring functionality to monitor RIP routing on routing devices.

To view RIP routing information in the J-Web interface, select Monitor > Routing > RIP Information.

To view RIP routing information in the CLI, enter the following CLI commands:

Table 1 summarizes key output fields in the RIP routing display in the J-Web interface.

Table 1: Summary of Key RIP Routing Output Fields

Field	Values	Additional Information
RIP Statistics
Protocol Name	The RIP protocol name.
Port number	The port on which RIP is enabled.
Hold down time	The interval during which routes are neither advertised nor updated.
Global routes learned	Number of RIP routes learned on the logical interface.
Global routes held down	Number of RIP routes that are not advertised or updated during the hold-down interval.
Global request dropped	Number of requests dropped.
Global responses dropped	Number of responses dropped.
RIP Neighbors
Neighbor	Name of the RIP neighbor.	This value is the name of the interface on which RIP is enabled. Click the name to see the details for this neighbor.
State	State of the RIP connection: Up or Dn (Down).
Source Address	Local source address.	This value is the configured address of the interface on which RIP is enabled.
Destination Address	Destination address.	This value is the configured address of the immediate RIP adjacency.
Send Mode	The mode of sending RIP messages.
Receive Mode	The mode in which messages are received.
In Metric	Value of the incoming metric configured for the RIP neighbor.