ANCP Operational Mode Commands
Table 1 summarizes the command-line interface (CLI) commands you can use to monitor and troubleshoot Access Node Control Protocol (ANCP) operations. Commands are listed in alphabetical order.
Table 1: ANCP Operational Mode Commands
Task | Command |
|---|---|
Clear ANCP neighbors. | |
Clear ANCP subscriber connections. | |
Trigger the access node to run a loopback test on the local loop specified by an ANCP interface or interface set. | |
Trigger the access node to run a loopback test on the local loop specified by an ANCP neighbor. | |
Display ANCP class-of-service information. | |
Display ANCP neighbor information. | |
Display ANCP subscriber information. | |
Display a summary of the counts and states for all ANCP neighbors and subscribers. | |
Display a summary of the counts and states for all ANCP neighbors and of the neighbor’s subscribers when you specify a particular neighbor. | |
Display a summary of the counts and states for all ANCP subscribers. |
 | Note: For information about how to configure ANCP, see the Junos Subscriber Access Configuration Guide. |
