VPN Operational Mode Commands
Table 1 summarizes the command-line interface (CLI) commands you can use to monitor and troubleshoot Layer 2 circuits, Layer 2 virtual private networks (VPNs), virtual private LAN service (VPLS), and Layer 3 VPNs. Commands are listed in alphabetical order.
Table 1: Layer 2 Circuit, Layer 2 VPN, and VPLS Operational Mode Commands
Task | Command |
|---|---|
Clear MAC address entries from the VPLS table. | |
Clear MAC addresses from the VPLS table. | |
Manually trigger a switch from the active pseudowire to the redundant pseudowire. | |
Display Layer 3 dynamic tunnel database information. | |
Display Host fast reroute (HFRR) profile information. | |
Display ingress replication provider tunnel information. | |
Display Layer 2 circuit information. | |
Display Layer 2 VPN information. | |
Display multicast VPN c-multicast route information. | |
Display multicast VPN instance information. | |
Display multicast VPN neighbor information. | |
Display virtual private LAN service (VPLS) information. | |
Display the pending events in the level 2 address learning process (l2ald) routing socket code (rtsock) update queue. | |
Display VPLS information related to the level 2 address learning process for the specified routing instance. | |
Display VPLS route information related to the level 2 address learning process. | |
Display learned VPLS MAC address information. | |
Display VPLS statistics. |
 | Note: For information about how to configure Layer 2 circuits, Layer 2 VPNs, VPLS, and Layer 3 VPNs, see the Junos VPNs Configuration Guide. |
