Supported Platforms
Related Documentation
Configuring ANCP
You can configure ANCP to enable a service-oriented Layer 3 edge device to discover information about the topology of a connected access network. ANCP can also provide details about subscriber traffic and enable the adjustment of QoS traffic shaping for subscribers.
To configure ANCP:
- Specify each ANCP neighboring access node to be monitored and optionally configure neighbor parameters.
- Specify the subscribers reached by a VLAN or a set of
VLANs through a particular access node.
See Associating an Access Node with Subscribers for ANCP Operations.
- (Optional) Configure the adjacency timer.
See Specifying the Interval Between ANCP Adjacency Messages.
- (Optional) Specify the maximum number of discovery table
entries that are accepted.
See Specifying the Maximum Number of Discovery Table Entries
- (Optional) Configure ANCP to work with an early IETF draft.
- (Optional) Configure the graceful restart timer.
See Specifying How Long Processes Wait for ANCP Restart to Complete.
- (Optional) Configure an adjustment factor per DSL line
type for the downstream and upstream data rates that the ANCP agent
reports to AAA.
See Setting a Global Adjustment Factor per DSL Subscriber Line for ANCP Agent-Reported Traffic Rates.
- (Optional) Configure the ANCP agent to report unadjusted
downstream traffic rates to CoS.
See Configuring the ANCP Agent to Report Traffic Rates to CoS.
- (Optional) Specify a recommended shaping rate to be applied
by RADIUS to downstream or upstream traffic per ANCP interface.
See Setting a Recommended Shaping Rate for Traffic on ANCP Interfaces.
- (Optional) Configure AAA to Include or Exclude Juniper
Networks DSL VSAs in RADIUS authentication and accounting messages.
See Configuring AAA to Include Juniper Networks DSL VSAs in RADIUS Messages.
- (Optional) Configure trace options for troubleshooting the configuration.
