Rate and give feedback:  Feedback Received. Thank You!

Rate and give feedback: 

X

This document helped resolve my issue

Yes No

Additional Comments

800 characters remaining

May we contact you if necessary?

Name:  

E-mail: 

Enter a valid Email ID

Need product assistance? Contact Juniper Support

Submit

This site is protected by hCaptcha and its Privacy Policy and Terms of Service apply.

English  

English

Configuring Layer 2 Protocol Tunneling on EX Series Switches (CLI Procedure)

Tunneled Layer 2 PDUs do not normally arrive at high rate. If the tunneled Layer 2 PDUs do arrive at high rate, there might be a problem in the network. Typically, you would want to shut down the interface that is receiving a high rate of tunneled Layer 2 PDUs so that the problem can be isolated. You do so using the shutdown-threshold statement. However, if you do not want to completely shut down the interface, you can configure the switch to drop tunneled Layer 2 PDUs that exceed a certain threshold using the drop-threshold statement.

There are no default settings for drop-threshold and shutdown-threshold. If you do not specify these thresholds, then no thresholds are enforced. As a result, the switch tunnels all Layer 2 PDUs regardless of the speed at which they are received, although the number of packets tunneled per second might be limited by other factors.

You can specify a drop threshold value without specifying a shutdown threshold value, and you can specify a shutdown threshold value without specifying a drop threshold value. If you specify both threshold values, then the drop threshold value must be less than or equal to the shutdown threshold value. If the drop threshold value is greater than the shutdown threshold value and you try to commit the configuration, the commit will fail.

Note: L2PT and VLAN translation configured with the mapping statement cannot both be configured on the same switch.

Note: If the switch receives untagged Layer 2 control PDUs to be tunnelled, then you must configure the switch to map untagged (native) packets to an L2PT-enabled VLAN. Otherwise, the untagged Layer 2 control PDU packets are discarded. For more information, see Understanding Q-in-Q Tunneling on EX Series Switches and Configuring Q-in-Q Tunneling (CLI Procedure).

1. Because L2PT operates under the Q-in-Q tunneling configuration, you must enable Q-in-Q tunneling before you can configure L2PT. Enable Q-in-Q tunneling on VLAN customer-1:
   [edit]
user@switch# set vlans customer-1 dot1q-tunneling
2. Enable L2PT for the Layer 2 protocol you want to tunnel, on the VLAN:
   • To enable L2PT for a specific protocol (here, STP):
     [edit]
user@switch# set vlans customer-1 dot1q-tunneling layer2-protocol-tunneling stp
   • To enable L2PT for all supported protocols:
     [edit]
user@switch# set vlans customer-1 dot1q-tunneling layer2-protocol-tunneling all
3. (Optional) Configure the drop threshold:

   Note: If you also configure the shutdown threshold, ensure that you configure the drop threshold value to be less than or equal to the shutdown threshold value. If the drop threshold value is greater than the shutdown threshold value and you to try to commit the configuration changes, the commit will fail.

   [edit]
user@switch# set vlans customer-1 dot1q-tunneling layer2–protocol-tunneling stp drop-threshold 50
4. (Optional) Configure the shutdown threshold:

   Note: If you also configure the drop threshold, ensure that you configure the shutdown threshold value to be greater than or equal to the drop threshold value. If the shutdown threshold value is less than the drop threshold value and you to try to commit the configuration changes, the commit will fail.

   [edit]
user@switch# set vlans customer-1 dot1q-tunneling layer2–protocol-tunneling stp shutdown-threshold 100

   Note: Once an interface is disabled, you must explicitly reenable it using the clear ethernet-switching layer2-protocol-tunneling error command. Otherwise, the interface remains disabled.