Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

TechLibrary
Navigation

Triggering an Ethernet Frame Delay Measurements Session

Before Ethernet frame delay measurement statistics can be displayed, they must be collected. To trigger Ethernet frame delay measurement, use the monitor ethernet delay-measurement (one-way | two-way) (remote-mac-address | mep identifier) maintenance-domain name maintenance-association ma-id [count count] [wait time] operational command.

The fields for this command are described in Table 1.

Table 1: Monitor Ethernet Delay Command Parameters

Parameter

Parameter Range

Description

one-way or two-way

NA

Perform a one-way or two-way (round-trip) delay measurement.

remote-mac-address

Unicast MAC address

Send delay measurement frames to the destination unicast MAC address (use the format xx:xx:xx:xx:xx:xx). Multicast MAC addresses are not supported.

mep identifier

1–8191

The MEP identifier to use for the measurement. The discovered MAC address for this MEP identifier is used.

maintenance-domain name

Existing MD name

Specifies an existing maintenance domain (MD) to use for the measurement.

maintenance-association ma-id

Existing MA identifier

Specifies an existing maintenance association (MA) identifier to use for the measurement.

count count

1–65535 (default: 10)

(Optional) Specifies the number of Ethernet frame delay frames to send. The default is 10.

wait time

1–255 seconds (default: 1)

(Optional) Specifies the number of seconds to wait between frames. The default is 1 second.

If you attempt to monitor delays to a nonexistent MAC address, you must exit the application manually using ^C:

user@host> monitor ethernet delay-measurement two-way 00:11:22:33:44:55
Two-way ETH-DM request to 00:11:22:33:44:55, Interface ge-5/2/9.0
^C
--- Delay measurement statistics ---
Packets transmitted: 10, Valid packets received: 0
Average delay: 0 usec, Average delay variation: 0 usec
Best case delay: 0 usec, Worst case delay: 0 usec
 

Related Documentation

 

Published: 2013-07-31

Previous Page Next Page