Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

TechLibrary
Navigation

Configuring 10-Gigabit Ethernet Framing

The 10-Gigabit Ethernet interfaces uses the interface type xe-fpc/pic/port. On single port devices, the port number is always zero.

The xe-fpc/pic/port interface inherits all the configuration commands that are used for gigabit Ethernet (ge-fpc/pic/port) interfaces.

To configure LAN PHY or WAN PHY operating mode, include the framing statement with the lan-phy or wan-phy option at the [edit interfaces xe-fpc /pic/0 ] hierarchy level.

[edit interfaces xe-fpc/pic/0 framing]framing (lan-phy | wan-phy);
  • The T4000 Core Router supports only LAN PHY mode in Junos OS Release 12.1R1. Starting with Junos OS Release 12.1R2, WAN PHY mode is supported on the T4000 routers with the 12-port 10-Gigabit Ethernet LAN/WAN PIC with SFP+ (PF-12XGE-SFPP). Starting with Junos OS Release 12.2, WAN PHY mode is supported on the T4000 routers with the 24-port 10-Gigabit Ethernet LAN/WAN PIC with SFP+ (PF-24XGE-SFPP).
  • On PTX Series Transport Routers, WAN PHY mode is supported only on the 24-port 10-Gigabit Ethernet LAN/WAN PIC with SFP+
  • When the PHY mode changes, interface traffic is disrupted because of port reinitialization.

To display interface information, use the operational mode command show interfaces xe-fpc/pic/port extensive.

  • SONET or SDH framing mode configuration framing (sdh | sonet) is not applicable on the 10-Gigabit Ethernet ports. Configuring the wan-phy framing mode on the 10-Gigabit Ethernet ports allows the interface to accept SONET or SDH frames without further configuration.
  • If you configure the WAN PHY mode on an aggregated Ethernet interface, you must set the aggregated Ethernet link speed to OC192.
 

Related Documentation

 

Published: 2013-08-01

Previous Page Next Page