[ Contents] [ Prev] [ Next] [ Index] [ Report an Error]

Applying the Dial-on-Demand Dialer Filter to the Dialer Interface

To complete dial-on-demand routing with dialer filter configuration:

  1. Navigate to the top of the interfaces configuration hierarchy in either the J-Web or CLI configuration editor.
  2. Perform the configuration tasks described in Table 63.
  3. When you are finished configuring the router, commit the configuration.
  4. Go on to any of the following optional tasks:
  5. To verify that the network interface is configured correctly, see Verifying the ISDN Configuration.

Table 63: Applying the Dialer Filter to the Dialer Interface

Task

J-Web Configuration Editor

CLI Configuration Editor

Navigate to the Interfaces level in the configuration hierarchy.

  1. In the J-Web interface, select Configuration>View and Edit>Edit Configuration.
  2. Next to Interfaces, click Edit.

From the [edit] hierarchy level, enter

edit interfaces dl0 unit 0

Select the dialer interface to apply the filter—for example, dl0.
  1. In the Interface name column, click dl0.
  2. Under Unit, in the Mtu column, click Edit.
 

Select the dialer filter and apply it to the dialer interface.
  1. In the Family section, next to Inet, click Edit.
  2. Next to Filter, click Configure.
  3. In the Dialer box, type int-packet, the dialer-filter configured in Configuring the Dialer Filter, as the dialer-filter.
  4. Click OK.
  1. Enter

    edit family inet filter

  2. Enter

    set dialer int-packet

[ Contents] [ Prev] [ Next] [ Index] [ Report an Error]

[an error occurred while processing this directive]