Removing the WXC ISM 200

The WXC ISM 200 is installed in the front of the Services Router.

Caution: Do not hot-swap WXC Integrated Services Modules or PIMs. Failure to power off the router before removing or installing a module might result in damage to the hardware.

To remove the WXC ISM 200:

1. Place an electrostatic bag or antistatic mat on a flat, stable surface to receive the WXC ISM 200.
2. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and connect the strap to the ESD point on the chassis, or to an outside ESD point if the Services Router is disconnected from earth ground. For more information about ESD, see the JUNOS Software with Enhanced Services Hardware Guide.
3. To power off the router, use the CLI command request system power-off (recommended), or hold down the power button for at least 2 seconds. Verify that the POWER LED blinks and then turns off.
4. Loosen the screws on each side of the WXC ISM 200 faceplate.
5. Grasp the handle on the WXC ISM 200 faceplate, and slide the module out of the router. Place it in the electrostatic bag or on the antistatic mat.
6. If you are not reinstalling a PIM or WXC ISM 200 in the emptied slots, install blank PIM panels over the slots to maintain proper airflow.