Help us improve your experience.

Let us know what you think.

Do you have time for a two-minute survey?

TechLibrary
Navigation

Synchronizing and Coordinating Time Distribution Using NTP

Using NTP to synchronize and coordinate time distribution in a large network involves these tasks:

  1. Configuring NTP
  2. Configuring the NTP Boot Server
  3. Specifying a Source Address for an NTP Server

Configuring NTP

Configuring the NTP Boot Server

When you boot the router or switch, it issues an ntpdate request, which polls a network server to determine the local date and time. You need to configure a server that the router or switch uses to determine the time when the router or switch boots. Otherwise, NTP will not be able to synchronize to a time server if the server’s time appears to be very far off of the local router’s or switch’s time.

  • To configure the NTP boot server, include the boot-server statement at the [edit system ntp] hierarchy level:
    [edit system ntp]boot-server (address | hostname);

Specify either the IP address or the hostname of the network server.

Specifying a Source Address for an NTP Server

For IP version 4 (IPv4), you can specify that if the NTP server configured at the [edit system ntp] hierarchy level is contacted on one of the loopback interface addresses, the reply always uses a specific source address. This is useful for controlling which source address NTP uses to access your network when it is either responding to or sending an NTP client request from your network.

To configure the specific source address that the reply will always use, and the source address that requests initiated by NTP server will use, include the source-address statement at the [edit system ntp] hierarchy level:

[edit system ntp]source-address source-address;

source-address is a valid IP address configured on one of the router or switch interfaces.

Note: If a firewall filter is applied on the loopback interface, ensure that the source address specified for the NTP server at the [edit system ntp] hierarchy level is explicitly included as one of the match criteria in the firewall filter. This enables the Junos OS to accept traffic on the loopback interface from the specified source address.

The following example shows a firewall filter with the source address 10.0.10.100 specified in the from statement included at the [edit firewall filter firewall-filter-name] hierarchy:

[edit firewall filter Loopback-Interface-Firewall-Filter]
term Allow-NTP {from {source-address {172.17.27.46/32; // IP address of the NTP server10.0.10.100/32; // Source address specified for the NTP server}then accept;}}

If no source address is configured for the NTP server, include the primary address of the loopback interface in the firewall filter.

 

Related Documentation

 

Published: 2013-01-23

Previous Page Next Page