Navigation
Supported Platforms
Testing a Subscriber AAA Configuration
Purpose
Display the AAA attributes that subscriber management assigns to the subscriber during login.
The following example tests the AAA configuration for a PPP subscriber. You can use the test aaa dhcp user command to perform a similar test for DHCP subscribers and the test aaa authd-lite user command to test authd-lite subscribers.
 | Note: The test command does not support volume-time accounting. If volume-time accounting is configured for the test subscriber, the test command replaces the statistics with time-only accounting statistics. |
Action
user@host>test aaa ppp user thomastank password 00N15& Authentication Grant
************User Attributes***********
User Name - thomastank
Client IP Address - 192.168.1.1
Client IP Netmask - 255.255.0.0
Virtual Router Name - default
Reply Message - NULL
Primary DNS IP Address - 0.0.0.0
Secondary DNS IP Address - 0.0.0.0
Primary WINS IP Address - 0.0.0.0
Secondary WINS IP Address - 0.0.0.0
Framed Pool - addr_pool2
Session Timeout - 0
Idle Timeout - 0
Service Type - 0
Client Ipv6 Address - ::
Client Ipv6 Mask - null
Framed Ipv6 Prefix - ::/0
Framed Ipv6 Pool - not-set
Nas Ipv6 Address - ::
NDRA Ipv6 Prefix - not-set
Login Ipv6 Host - ::
Framed Interface Id: - 0:0:0:0
Delegated Ipv6 Prefix - ::/0
Delegated Ipv6 Pool - not-set
User Password - 00N15&
CHAP Password - NULL
NAS Ip Address - 0.0.0.0
NAS Port - 0
NAS Port Type - 5
Client Session Activate request sent
Client Session Activated
Filter Id - not set
Framed MTU - (null)
Framed Route - not set
Ingress Policy Name - not set
Egress Policy Name - not set
IGMP - disabled
Redirect VR Name - default
Service Bundle - Null
Framed Ip Route Tag - not set
LI Action - 0
LI Intercpet Id - 0
Med Ipaddress - 0.0.0.0
Med Port Number - 0
Ignore DF Bit - disabled
IGMP Access Group Name - not set
IGMP Access Source Group Name - not set
MLD Access Group Name - not set
MLD Access Source Group Name - not set
IGMP Version - IGMP Version not set
MLD Version - MLD Version not set
IGMP Immediate Leave - disabled
MLD Immediate Leave - disabled
IPv6 Ingress Policy Name - not set
IPv6 Egress Policy Name - not set
Cos Parameter Type - not-set
Cos Scheduler Parameter Type - not-set
Acct Session ID- 8
Acct Interim Interval - 0
Acct Type - 0
Ingress Statistics disabled
Egress Statistics disabled
****Pausing 10 seconds before disconnecting the test user*********
Logging out subscriber
Test complete. Exiting
