• Downloads
• ntp    

• Related Topics
• Configuring the NTP Server

ntp

Syntax

ntp -T system:mm[x] <-en (enabled | disabled)> <-i ip-address | hostname> <-f update-frequency> <-synch>

Release Information

Command supported by JUNOS Release 9.1 and later.

Description

(JCS management module CLI) Configure or display the JCS management module network time protocol (NTP) settings.

Options

-T system:mm[x]—Specify a JCS management module as the command target. Replace x with the primary management module number (1 or 2). The JCS management module is the only valid target available for this command.

-en (enabled | disabled)—(Optional) Enable or disable NTP for the JCS management module.

-i ip-address|hostname—(Optional) IP address or hostname of the NTP server.

-f update-frequency—(Optional) Update frequency (in minutes). The JCS management module clock is automatically updated at the frequency specified. Replace update-frequency with a value from 1 through 45000.

-synch—(Optional) Synchronize the JCS management module clock with the NTP server.

Required Privilege Level

operator (display)

supervisor (display or configure)

List of Sample Output

Output Fields

Table 1 lists the output fields for the ntp command. Output fields are listed in the approximate order in which they appear.

Table 1: ntp Output Fields

Sample Output

-en enabled
-i timeserver
-f 5
-v3en disabled

OK