- play_arrow Installation
- play_arrow Troubleshoot
Power-On Options for the AP41
You can use any of the following options to power on an AP41:
Power over Ethernet Plus (PoE+) from an Ethernet switch
We recommend that you use an Ethernet cable with a maximum length of 100 m to connect the access point (AP) to the switch port.
If you use an Ethernet cable that is longer than 100 m by placing an Ethernet PoE+ extender in the path, the AP might power up, but the Ethernet link does not transmit data across such a long cable. You might see the status LED blink yellow twice. This LED behavior indicates that the AP is unable to receive data from the switch.
PoE injector
12 VDC power supply
See PoE Requirements for Juniper Mist APs for the power requirements for an AP41.