close

keyboard_arrow_left

Table of Contents Expand all

play_arrow Fast Track: Initial Installation
- Fast Track to Rack Installation and Power
- Claim, Onboard, and Configure SRX1600
play_arrow Overview
play_arrow Site Planning, Preparation, and Specifications
play_arrow Initial Installation and Configuration
play_arrow Maintaining Components
play_arrow Troubleshooting Hardware
- Troubleshoot the SRX1600
play_arrow Contact Customer Support and Returning the Chassis or Components
- Contacting Customer Support and Returning the Chassis or Components
play_arrow Safety and Compliance Information
- Safety Information
- SRX1600 Agency Approvals

list Table of Contents

English

SRX1600 Cooling System Maintenance

date_range 25-Jul-23

arrow_backward

arrow_forward

Maintaining the SRX1600 includes removing and installing the fans.

The SRX1600 has three independent, field-replaceable fans at the rear of the chassis.

Each fan module is a hot-removable and hot-insertable field-replaceable unit (FRU). You can remove and replace the fan module without turning off power to the appliance or disrupting its functions.

Before you replace a fan module:

Ensure that you understand how to prevent electrostatic discharge (ESD) damage.
Ensure that you have the following parts and tools:
- An ESD grounding strap
- An antistatic bag or an antistatic mat
- A replacement fan module
- (Optional) A Phillips (+) screwdriver, number 1 or 2, for the captive screws

Remove the Fan Module from the SRX1600

CAUTION:

Do not remove a fan unless a replacement fan is available.

To remove a fan:

Wrap and fasten one end of the ESD grounding strap around your bare wrist, and connect the other end of the strap to one of the ESD points on the chassis.
Place the antistatic bag or the antistatic mat on a flat, stable surface.
Loosen the captive screws on the front faceplate of the fan module by using your fingers. If you can't loosen the captive screws by using your fingers, use the screwdriver.

Warning:
To prevent injury, do not touch the fan with your hands or any tools when you slide the fan module out of the chassis—the fan might still be running.
Grasp the handle on the fan module and pull it firmly to slide the fan out of the chassis.
Figure 1: Remove the Fan Module from the SRX1600
Place the fan module in the antistatic bag or on the antistatic mat.

Install the Fan Module in the SRX1600

To install a fan:

Wrap and fasten one end of the ESD grounding strap around your bare wrist, and connect the other end of the strap to one of the ESD points on the chassis.
Remove the fan module from its bag.
Hold the handle of the fan module with one hand and support the weight of the module with the other hand. Place the fan module in the fan module slot on the rear panel of the switch and slide the module in until it is fully seated.
Figure 2: Install the Fan Module on the SRX1600
Tighten the captive screws on the faceplate of the fan module by using your fingers. If you can't tighten the captive screws by using your fingers, use the screwdriver.

arrow_backward PREVIOUS Routine Maintenance Procedures for the SRX1600

NEXT arrow_forward SRX1600 Power Supply Maintenance

SRX1600 Firewall Hardware Guide

ON THIS PAGE

SRX1600 Cooling System Maintenance

Remove the Fan Module from the SRX1600

Install the Fan Module in the SRX1600

Stay in touch

Helped me install or use the product
Accelerated my deployment

Discuss the product with a co-worker
Make a purchase inquiry